Im having problems with a HD3850 AGP that locks up in both 2D and 3D when working on the computer. If I just let it run it doesn't hang. Figured it could be a PSU problem I ran the HD3850 off an second 450w psu dedicated to the graphicscard without luck. Runs Windows XP fine and 3DMark 06 fine without any lockups.
Lockup almost instantly if I open a couple of tabs in FireFox 3 and drag the whole window. Sometimes it locksup and the monitor goes to sleep and sometimes it just freezes the computer with the Desktop visible.
Doom3, Quake 4 and ETQW runs OK until it freezes under CentOS (5-15minutes usually)
xorg.conf configured with aticonfig --initial. No special options at all.
Tested booting with NOPAT without any luck.
Any people with ATI HD38xx and this kind of problems ?
Will testrun a few games under Windows later today and get back with the results.
Computer Specs
CentOS 5.2
P4 2.53GHz
768MB RAM
Promise SATA 300 TX4 with 2x1TB Seagate
Radeon HD3850 512MB AGP
Catalyst 8.8 (Same problems with Catalyst 8.7)
Lockup almost instantly if I open a couple of tabs in FireFox 3 and drag the whole window. Sometimes it locksup and the monitor goes to sleep and sometimes it just freezes the computer with the Desktop visible.
Doom3, Quake 4 and ETQW runs OK until it freezes under CentOS (5-15minutes usually)
xorg.conf configured with aticonfig --initial. No special options at all.
Tested booting with NOPAT without any luck.
Any people with ATI HD38xx and this kind of problems ?
Will testrun a few games under Windows later today and get back with the results.
Computer Specs
CentOS 5.2
P4 2.53GHz
768MB RAM
Promise SATA 300 TX4 with 2x1TB Seagate
Radeon HD3850 512MB AGP
Catalyst 8.8 (Same problems with Catalyst 8.7)
Comment