That's a nice looking case. Does anyone know where I can buy the gray/black one? I'd like it for my own build. All the low profile mini-ITX cases I've seen just look so cheap.
Hard to tell because i used some "salvaged" (build was OK but micro-ATX is too big ) parts from a micro-ATX build....however, by my calculations, if i lived in US, i believe i could make it in same price ranges than Lini PC with these specs that i consider better.
Originally Posted by Ericg
This build have margin to expand, for example, no matter case is so small, i could keep SlimODD and install both a SSD (120GB,) 7mm thick and a HDD (WD 1TB,) 7mm thick using a system where HDD is screwed to drives holder and then, SSD is screwed to HDD using two sideways fiberglass plates.
I done it in the past and works very well.
Another alternative is...
Discard SlimODD, use shorter springs and screws for heatsink installation, and then....brace yourselves.... install a fat 4TB 3.5" HDD and a 2.5" 120/240 GB SSD
This is only possible thanks to AsRock use in this MoBos that weird position for the DIMMs....in this case , is a decisive positive factor.