I'm running the phoronix test suite and I'm using the command phoronix-test-suite benchmark pts/disk.
The program runs fine but I have an SSD as the primary drive and an WD3tb as a secondary.
I need to run the tests on both hard drives in this system and show the different results for each drive. Is that possible? Is there a command after I run the test to tell which drive to test?
The program runs fine but I have an SSD as the primary drive and an WD3tb as a secondary.
I need to run the tests on both hard drives in this system and show the different results for each drive. Is that possible? Is there a command after I run the test to tell which drive to test?
Comment