Hi I have a USB tablet (which is not directly supported on Linux) this is correctly detected as mouse and performs correctly as a mouse on Mandriva and earlier versions of Ubuntu.
But in Ubuntu 8.14, my mouse clicks are getting translated as motion instead of Clicks. I have checked this using xev and "xinput test"
I have played around with xinput, xmodmap but the results are the same.
My Xlog shows that:
(II) config/hal: Adding input device Ntk
(**) Ntk: always reports core events
(**) Ntk: Device: "/dev/input/event6"
(II) Ntk: Found x and y relative axes
(II) Ntk: Found x and y absolute axes
(II) Ntk: Found absolute touchpad
(II) Ntk: Found 2 mouse buttons
(II) Ntk: Configuring as mouse
(II) XINPUT: Adding extended input device "Ntk" (type: MOUSE)
(**) Ntk: YAxisMapping: buttons 4 and 5
(**) Ntk: EmulateWheelButton: 4, EmulateWheelInertia: 10, EmulateWheelTimeout: 200
I would like to know if:
1. Is there a better way to identify and configure the buttons correctly?
2. Do we have to tweak usbhid/evdev?
Thanks
smaniam
But in Ubuntu 8.14, my mouse clicks are getting translated as motion instead of Clicks. I have checked this using xev and "xinput test"
I have played around with xinput, xmodmap but the results are the same.
My Xlog shows that:
(II) config/hal: Adding input device Ntk
(**) Ntk: always reports core events
(**) Ntk: Device: "/dev/input/event6"
(II) Ntk: Found x and y relative axes
(II) Ntk: Found x and y absolute axes
(II) Ntk: Found absolute touchpad
(II) Ntk: Found 2 mouse buttons
(II) Ntk: Configuring as mouse
(II) XINPUT: Adding extended input device "Ntk" (type: MOUSE)
(**) Ntk: YAxisMapping: buttons 4 and 5
(**) Ntk: EmulateWheelButton: 4, EmulateWheelInertia: 10, EmulateWheelTimeout: 200
I would like to know if:
1. Is there a better way to identify and configure the buttons correctly?
2. Do we have to tweak usbhid/evdev?
Thanks
smaniam