Hi, I'm new here and I have a few doubts about your great suite of benchmarking.
1) Why my proccessor is no detected correcly? Same case with my memory.
Show the results like this:
2) Why the sensors not works properly during bench?
====================================
LM Sensors (Run 1 of 1)
====================================
FAIL,FAIL,FAIL,FAIL,PASS,PASS,PASS
################################################## ####
LM Sensors:
(VCore, +3.3V, +5V, +12V, CPU Fan, CPU Temp, Sys Temp)
Final: FAIL,FAIL,FAIL,FAIL,PASS,PASS,PASS
################################################## ####
But the daemon sensors works fine.:S
I try $ phoronix-test-suite sensor-options:
But I don't have to use properly.
Use Arch Linux i686 x32 - E7200 @3,6 - 1024 mb Kingston DDR2 800 mhz 4-4-4-12 - HD Seagate 320 gigas S-ATA II - GeForce 7300GT - GA-P35-DS3P
Thanxs in advance.
1) Why my proccessor is no detected correcly? Same case with my memory.
Show the results like this:
2) Why the sensors not works properly during bench?
Code:
$ ./phoronix-test-suite run compliance-sensors
LM Sensors (Run 1 of 1)
====================================
FAIL,FAIL,FAIL,FAIL,PASS,PASS,PASS
################################################## ####
LM Sensors:
(VCore, +3.3V, +5V, +12V, CPU Fan, CPU Temp, Sys Temp)
Final: FAIL,FAIL,FAIL,FAIL,PASS,PASS,PASS
################################################## ####
But the daemon sensors works fine.:S
I try $ phoronix-test-suite sensor-options:
Code:
$ ./phoronix-test-suite sensor-options Monitoring these sensors are as easy as running your normal Phoronix Test Suite commands but at the beginning of the command add: MONITOR=<selected sensors> (example: MONITOR=cpu.temp,cpu.voltage phoronix-test-suite benchmark universe). Below are all of the sensors supported by this version of the Phoronix Test Suite. Supported Options: - all - all.temp - all.power - all.voltage - all.freq - all.usage - gpu.temp - cpu.temp - sys.temp - battery.power - cpu.voltage - v3.voltage - v5.voltage - v12.voltage - cpu.freq - gpu.usage
Use Arch Linux i686 x32 - E7200 @3,6 - 1024 mb Kingston DDR2 800 mhz 4-4-4-12 - HD Seagate 320 gigas S-ATA II - GeForce 7300GT - GA-P35-DS3P
Thanxs in advance.
Comment