Hi, I'm new here and I have a few doubts about your great suite of benchmarking.

1) Why my proccessor is no detected correcly? Same case with my memory.
Show the results like this:



2) Why the sensors not works properly during bench?
Code:
$ ./phoronix-test-suite run compliance-sensors
====================================
LM Sensors (Run 1 of 1)
====================================

FAIL,FAIL,FAIL,FAIL,PASS,PASS,PASS

################################################## ####
LM Sensors:

(VCore, +3.3V, +5V, +12V, CPU Fan, CPU Temp, Sys Temp)

Final: FAIL,FAIL,FAIL,FAIL,PASS,PASS,PASS

################################################## ####

But the daemon sensors works fine.:S
I try $ phoronix-test-suite sensor-options:
Code:
$ ./phoronix-test-suite sensor-options

Monitoring these sensors are as easy as running your normal Phoronix Test Suite commands but at the beginning of the command add: MONITOR=<selected sensors> (example: MONITOR=cpu.temp,cpu.voltage phoronix-test-suite benchmark universe). Below are all of the sensors supported by this version of the Phoronix Test Suite.

Supported Options:
  - all
  - all.temp
  - all.power
  - all.voltage
  - all.freq
  - all.usage
  - gpu.temp
  - cpu.temp
  - sys.temp
  - battery.power
  - cpu.voltage
  - v3.voltage
  - v5.voltage
  - v12.voltage
  - cpu.freq
  - gpu.usage
But I don't have to use properly.


Use Arch Linux i686 x32 - E7200 @3,6 - 1024 mb Kingston DDR2 800 mhz 4-4-4-12 - HD Seagate 320 gigas S-ATA II - GeForce 7300GT - GA-P35-DS3P


Thanxs in advance.