Sapphire x1650 Pro AGP and radeonhd

[Grey Goshawk]

Hey everyone, after hearing the success of getting 3D on the radeonhd drivers I decided to try them out seeing as installing the fglrx drivers gives me a black screen and lockup.
The driver works great in 2D acceleration but whenever I enable DRI in my xorg.conf, the 2d acceleration slows down considerable: scrolling on firefox causes the whole screen to lag.

Looking at my xorg log it seems that this error repeats itself looking at a whole list of devices but not being about to find anything.
Any help would be appreciated

drmOpenDevice: node name is /dev/dri/card0
drmOpenDevice: open result is -1, (No such device or address)
drmOpenDevice: open result is -1, (No such device or address)
drmOpenDevice: Open failed
drmOpenByBusid: Searching for BusID pci:0000:01:00.0
drmOpenDevice: node name is /dev/dri/card0
drmOpenDevice: open result is -1, (No such device)
drmOpenDevice: open result is -1, (No such device)
drmOpenDevice: Open failed
drmOpenByBusid: drmOpenMinor returns -19
drmOpenDevice: node name is /dev/dri/card1
drmOpenDevice: open result is -1, (No such device)
drmOpenDevice: open result is -1, (No such device)
drmOpenDevice: Open failed
drmOpenByBusid: drmOpenMinor returns -19
drmOpenDevice: node name is /dev/dri/card2
drmOpenDevice: open result is -1, (No such device)
drmOpenDevice: open result is -1, (No such device)
drmOpenDevice: Open failed
drmOpenByBusid: drmOpenMinor returns -19
drmOpenDevice: node name is /dev/dri/card3
drmOpenDevice: open result is -1, (No such device)
drmOpenDevice: open result is -1, (No such device)
drmOpenDevice: Open failed
drmOpenByBusid: drmOpenMinor returns -19
drmOpenDevice: node name is /dev/dri/card4
drmOpenDevice: open result is -1, (No such device)
drmOpenDevice: open result is -1, (No such device)
drmOpenDevice: Open failed

Then at the end of this part
(EE) RADEONHD(0): [dri] RHDDRIGetVersion failed to open the DRM
[dri] Disabling DRI.

[adamk]

Please show us your *full* Xorg.0.log file as well as the output of 'dmesg | grep drm'.

Also, you should know that, last I heard, 2D and 3D acceleration does not work at the same time with the radeonhd driver, but it should work fine with the 'radeon' driver.

Adam

[Grey Goshawk]

There's the result from the grep
# dmesg | grep drm
[62.313742] [drm] Initialized drm 1.1.0 20060810



Here's a link to my xorg log
http://freetexthost.com/us1xcjosm5

[adamk]

I'm guessing that your DRM is too old. Did you update that from git, too? What's the output of 'lsmod | grep radeon' ? If it's not showing up there, run 'sudo modprobe radeon' and then check the output of 'dmesg | grep drm' again.

Adam

[Grey Goshawk]

jonathan@jonathan-desktop:~$ lsmod | grep radeon
radeon 124192 0
drm 82452 1 radeon

yeah, I did update it from git. Well I followed the instructions that are on the xorg wiki. It seemed to work.

[adamk]

Still no output from 'dmesg | grep drm' ? How about if you do a 'sudo rmmod radeon && sudo modprobe radeon'. Anything in the dmesg then?

Adam

[Grey Goshawk]

jonathan@jonathan-desktop:~$ dmesg | grep drm
[ 62.313742] [drm] Initialized drm 1.1.0 20060810

That's what I get, I guess the fact that it's from 2006 indicates that there's a problem, I assume?

[adamk]

No, 2006 is right for the drm module. However, you should also get something like:

[drm] Initialized radeon 1.29.0 20080528 on minor 0
[drm] Setting GART location based on new memory map
[drm] Loading R500 Microcode

Can you tell me exactly what steps you took to update your DRM?

Adam

[Grey Goshawk]

I followed the steps here to update the DRM
http://www.x.org/wiki/radeonhdRI

But I seem to be getting errors about opening a minor, so perhaps there's a problem that's stopping it from loading properly?
drmOpenDevice: node name is /dev/dri/card3
drmOpenDevice: open result is -1, (No such device)
drmOpenDevice: open result is -1, (No such device)
drmOpenDevice: Open failed
drmOpenByBusid: drmOpenMinor returns -19

[adamk]

Xorg just isn't finding the dri device, but that's because the kernel module isn't loading.

What's the output of 'find /lib/modules/`uname -r`/ -iname "radeon.ko" -exec ls -la {} \; '