If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Yes, then we have even seen numbers on low-jitter.
First of all, a kernel with "low latency desktop" enabled. You can edit Kconfig.hz and change 100 to 90. (search/replace).
You can add idle=poll and tick_skew=1 to boot options. And compile a shaved local kernel by doing "make localmodconfig" from a full distro kernel. (Also remember to turn of high_res_timers if enabled, because then hz will be 4016 or atleast high.)
CFS granularity should be set to 1158500nS. (Current setting is a bit high, and may give jitter)
Renice X to -20, to prevent X being a bottleneck.
Remove 60hz limit in doom 3, to avoid timing jitter. http://paradoxuncreated.com/tmp/AutoExec.cfg
So as I said, I ordered a computer with components optimized for latency. An E5 workstation, which I installed a GTX660 in also. HexaCore. What can I say, I am very pleased with the results. This is the kind of computer I have wanted for a long time. Highly recommened for all low-jitter enthusiasts, and media professionals. Even windows (xp) runs 1ms streams now, with webcam recording at the same time, without drop of frames or clicks.